Sonoff Zigbee Bridge pro: Porovnání verzí
Skočit na navigaci
Skočit na vyhledávání
Bez shrnutí editace značka: přepnuto z Vizuálního editoru |
Bez shrnutí editace |
||
| Řádek 20: | Řádek 20: | ||
Download tasmota32-zbbrdgpro.factory.bin from https://ota.tasmota.com/tasmota32/release/ [[https://ota.tasmota.com/tasmota32/release/]] | Download tasmota32-zbbrdgpro.factory.bin from https://ota.tasmota.com/tasmota32/release/ [[https://ota.tasmota.com/tasmota32/release/]] | ||
<pre>python3 /path to esptool/esptool.py --port /dev/ttyUSB0 write_flash 0x0 /path to bin file/tasmota32-zbbrdgpro.factory.bin | <pre>python3 /path to esptool/esptool.py --port /dev/ttyUSB0 write_flash 0x0 /path to bin file/tasmota32-zbbrdgpro.factory.bin</pre> | ||
Turn off zb bridge and Disconnect GPIO00 from GND. | Turn off zb bridge and Disconnect GPIO00 from GND. | ||
Verze z 17. 2. 2026, 13:38
Flash tasmota to the ZB Bridge pro is more than easy instead of non-pro version, lets follow ->
Connect board of ZB Bridge to the programmer.
| Sonoff ZB Bridge PRO | FTD programmer |
|---|---|
| 3V3 | Vcc/3V3 |
| GND | GND |
| RX | TX |
| TX | RX |
| GPIO00 | GND (first run-enable flash mode) |
Download tasmota32-zbbrdgpro.factory.bin from https://ota.tasmota.com/tasmota32/release/ [[1]]
python3 /path to esptool/esptool.py --port /dev/ttyUSB0 write_flash 0x0 /path to bin file/tasmota32-zbbrdgpro.factory.bin
Turn off zb bridge and Disconnect GPIO00 from GND.
Turn on zb bridge and setup wifi.
For HomeAssistant -> ZHA or Zigbee2MQTT, open the web UI of the device and navigate to Configuration -> Auto-configuration. Select Sonoff ZBPro TCP from the drop-down and click Apply Configuration. The device will restart and will be automagically configured.
sources https://notenoughtech.com/home-automation/tasmota-on-sonoff-zb-bridge-pro/#flash [[2]] https://zigbee.blakadder.com/Sonoff_ZBBridge-P.html [[3]]